Friction Formula Solver with Worked Examples

The maximum (limiting) friction between two rough surfaces is , where is the coefficient of friction and is the normal reaction. The calculator finds , or .

Write 2x or 2*x to multiply, ^ for powers, and ; between simultaneous equations. You can also type factor, expand, derivative of, integrate … from a to b, limit … as x->0 or 15% of 80.

Try an example

Give every value except the one you want, or write the letter with a question mark, for example c=0.4, R=50 or F=18, R=60. Every answer is checked by putting it back into the formula.

  • : limiting friction ()
  • : coefficient of friction
  • : normal reaction ()

Before you start

This page is easier if you are comfortable with:

What Friction means

Friction opposes the motion, or the tendency to move, between two surfaces. It acts along the surface, in the direction that stops the sliding.

The friction force can take any value up to a limit: . When the object is about to slip, or is sliding, . When the object is not on the point of moving, the friction is just enough to balance the other forces, which may be less than .

The normal reaction is the force the surface pushes back with, at right angles to the surface. On a flat horizontal surface with no other vertical forces ; on a slope or with a pulling force at an angle, is different. The slope version is inclined plane: components of weight, the limit case is limiting equilibrium on a rough slope, and the force law is Newton second law.

This page is part of Forces, friction and equilibrium in Mechanics. Topics that work alongside it: Inclined plane: components of weight, Limiting equilibrium on a rough slope, Newton's second law, Connected particles over a pulley, Vector form of motion and Projectile: horizontal and vertical motion.

What is it used for?

Friction is the force that resists sliding between two rough surfaces. The model F = μR gives its maximum value.

How to use the friction formula

  1. Draw the force diagram with weight, normal reaction, friction and any other forces.
  2. Resolve perpendicular to the surface to find .
  3. Use if the object is sliding or about to slide.
  4. Resolve along the surface and use or equilibrium.

Diagram

mmgRPF

The friction force F acts opposite to the push P. At the point of sliding, F = μR, where R is the normal reaction.

Worked examples

Each example below was worked out by the solver on this page and checked by substituting the answer back into the formula.

Example 1: find the limiting friction

A block rests on rough ground with coefficient of friction 0.4 and normal reaction 50 N. Find the limiting friction.

Friction Answer checked
Answer
F=20 NF=20\ \text{N}
  1. The formula
    Friction. In this formula is the limiting friction, is the coefficient of friction, is the normal reaction.
  2. What we know and what we want
    We know and we want to find , the limiting friction.
  3. Substitute the numbers
  4. Calculate
  5. Check by substituting back
    Put all the values back into the original formula: both sides should match.

Example 2: find the coefficient

A box is about to slide. The friction force is 18 N and the normal reaction is 60 N. Find μ.

Friction Answer checked
Answer
μ=0.3\mu=0.3
  1. The formula
    Friction. In this formula is the limiting friction, is the coefficient of friction, is the normal reaction.
  2. What we know and what we want
    We know and we want to find , the coefficient of friction.
  3. Rearrange for
    Divide both sides by R.
  4. Substitute the numbers
  5. Calculate
  6. Check by substituting back
    Put all the values back into the original formula: both sides should match.

Example 3: find the normal reaction

The limiting friction is 24 N and μ = 0.3. Find the normal reaction.

Friction Answer checked
Answer
R=80 NR=80\ \text{N}
  1. The formula
    Friction. In this formula is the limiting friction, is the coefficient of friction, is the normal reaction.
  2. What we know and what we want
    We know and we want to find , the normal reaction.
  3. Rearrange for
    Divide both sides by μ.
  4. Substitute the numbers
  5. Calculate
  6. Check by substituting back
    Put all the values back into the original formula: both sides should match.

Special cases

A few situations come up again and again. Knowing them saves time and helps you spot answers that cannot be right.

Not about to move

10 kg box, μ = 0.4, R = 98: F_max = 39.2, but a 20 N push gives friction of 20 N

Friction balances the push, up to the maximum.

The normal reaction on a slope

R = mg cos θ = 10 × 9.8 × cos 30° ≈ 84.87

Not mg. Resolve the weight perpendicular to the slope.

Pulling at an angle

R = mg − T sin θ = 98 − 20 sin 30° = 88

An upward component of the pull reduces R.

A smooth surface

μ = 0: F = 0

There is no friction, whatever R is.

Limiting friction F = μR
μR (N)F_max (N)
0.45020
0.38024
0.59849
0.1989.8

Word problems

Find the normal reaction R first, then use F = μR if the object is about to slip or is sliding. Otherwise the friction only balances the other forces.

Limiting friction

A crate has μ = 0.4 and the normal reaction is 50 N. Find the limiting friction.

  1. Write the formulaF = μR
  2. SubstituteF = 0.4 × 50
  3. CalculateF = 20 N
  4. Check: 20 ÷ 50 = 0.4 ✓The limiting friction is 20 N.

The coefficient

A box on the point of slipping has friction of 18 N and the normal reaction is 60 N. Find μ.

  1. Rearrangeμ = F ÷ R
  2. Substituteμ = 18 ÷ 60
  3. Calculateμ = 0.3
  4. Check: 0.3 × 60 = 18 ✓The coefficient of friction is 0.3.

Will it move? Higher

A 10 kg box on a rough horizontal floor has μ = 0.4. A horizontal force of 30 N is applied. Does the box move?

  1. The normal reactionR = 10 × 9.8 = 98 N
  2. The limiting frictionF_max = 0.4 × 98 = 39.2 N
  3. Compare30 N < 39.2 N
  4. Check: friction only needs to be 30 N to balance the push ✓The box does not move, and the friction is 30 N.

Pulling at an angle Higher

A 20 kg box is pulled by a rope with a force of 50 N at 30° above the horizontal. The coefficient of friction is 0.2. Find the acceleration.

  1. The normal reactionR = 20 × 9.8 − 50 sin 30° = 196 − 25 = 171 N
  2. The limiting frictionF = 0.2 × 171 = 34.2 N
  3. The horizontal pull50 cos 30° = 43.30 N
  4. The resultant and acceleration(43.30 − 34.2) ÷ 20 = 0.455 m s⁻²
  5. Check: 43.30 > 34.2, so the box moves ✓The acceleration is about 0.455 m s⁻².

Common mistakes

Using F = μR when the object is not about to move

pushing with 20 N: friction = 0.4 × 98 = 39.2 N ✗

friction = 20 N, equal to the push ✓

F = μR is only the maximum value.

Assuming R = mg on a slope

10 kg on a 30° slope: R = 98 N ✗

R = 10 × 9.8 × cos 30° = 84.87 N ✓

Resolve the weight perpendicular to the slope.

Drawing the friction in the wrong direction

friction pointing the way the object moves ✗

friction opposes the motion or the tendency to move ✓

It acts along the surface in the opposite direction.

Ignoring a vertical component of the pull

rope at 30°: R = 196, F = 0.2 × 196 = 39.2 ✗

R = 196 − 25 = 171, F = 34.2 ✓

An upward component of the pull reduces the normal reaction.

Dividing instead of multiplying

F = R ÷ μ = 50 ÷ 0.4 = 125 N ✗

F = μR = 20 N ✓

Friction is the coefficient times the normal reaction.

Using the weight in place of R

always using F = μmg ✗

find R from the forces perpendicular to the surface ✓

R equals mg only on a horizontal surface with no other vertical forces.

Exam tips

  1. Draw a force diagram with weight, R, friction and any applied force.
  2. Find R first by resolving perpendicular to the surface.
  3. Use F = μR only when the object is about to slip or is sliding.
  4. Otherwise find F by balancing forces along the surface, and check that F ≤ μR.
  5. Friction opposes the motion or the tendency to move.
  6. Use Newton’s second law in the direction of motion: see Newton’s second law.

Practice questions

Try each one on paper, then open the answer. Use the solver above to see the full working.

1. A crate has μ = 0.5 and the normal reaction is 80 N. Find the limiting friction Foundation

F = 0.5 × 80 = 40 N

2. A box on the point of slipping has friction of 24 N and R = 80 N. Find μ Foundation

μ = 24 ÷ 80 = 0.3

3. The limiting friction is 24 N and μ = 0.3. Find the normal reaction Foundation

R = 24 ÷ 0.3 = 80 N

4. A 5 kg block rests on a rough floor with μ = 0.6. Find the limiting friction Higher

R = 5 × 9.8 = 49 N, so F = 0.6 × 49 = 29.4 N

5. A 10 kg block on a 30° slope has μ = 0.3. Find the limiting friction to 2 decimal places Higher

R = 98 cos 30° = 84.87 N, so F = 0.3 × 84.87 = 25.46 N

6. A 10 kg box is pushed by a horizontal force of 25 N on a floor with μ = 0.4. Does it move? Higher

F_max = 0.4 × 98 = 39.2 N, which is more than 25 N, so it does not move and the friction is 25 N

Practice generator

Unlimited fresh questions with instant marking. Choose a level, work it out on paper, then type your answer.

Solve: …

Key terms

Friction
A force along a surface that opposes sliding.
Coefficient of friction (μ)
A number that tells you how rough the surfaces are.
Normal reaction (R)
The force from a surface, at right angles to the surface.
Limiting friction
The maximum friction, μR, when the object is about to slip.
Rough surface
A surface with friction.
Smooth surface
A surface with no friction.
Equilibrium
No resultant force, so no acceleration.
Resolve
Split a force into perpendicular components.

Frequently asked questions

What is the formula for friction?

The maximum friction is F = μR, where μ is the coefficient of friction and R is the normal reaction.

What is the coefficient of friction?

A number μ that depends on the two surfaces. A larger μ means more friction.

Is friction always equal to μR?

No. F = μR is the maximum. If the object is not about to slip, friction only balances the other forces and F < μR.

What is the normal reaction?

The force from the surface on the object, perpendicular to the surface.

Does friction depend on area?

In the simple model, no. It depends only on μ and R.

How does friction work on a slope?

See limiting equilibrium on a rough slope and components of weight.

More in Mechanics and the formula sheets.